Important Notes for Windows NT 4.0

Installing ScanWizard and the Adaptec card under Windows NT V4.0

Important: In order to install the ScanWizard software and your 
Adaptec interface card, you must be logged in as an administrator 
or have administrator-level access to the system files.

A.   Installing the Adaptec 1502E or 1502AE interface card:

If you already have a functioning Adaptec card in your computer, go to
step B. If you are installing the Adaptec 1502E or 1502AE card in your
computer for the first time, you need to make sure IRQ11
(Interrupt Request #11) is available.

To find your IRQ:
Go to Start; Programs; then WinNT diagnostics. Click the resources tab,
press the IRQ button, then take note of the following:

If IRQ 11 appears in the dialog box, this means it taken by
another device. In this case, you need to change the IRQ setting of
that device to free up IRQ11 for the Adaptec card to be used.
(You can call your computer manufacturer or systems administrator
for help on this.)

If IRQ 11 does NOT appear in the dialog box, this means it is available.
In this case, do the following:

1.    Start up your computer. Go to Start; Settings; then Control Panel.
2.    Double-click on SCSI Adapters.
3.    Click on the Driver tab, then click on the Add button.
4.    Select Adaptec on the left hand side, and AHA-152X / AHA1510 SCSI
      Host Adapter on the right. (This option is used for an Adaptec 
      card.)
5.    Insert your WinNT disk or CD when prompted, then shut down and 
      restart the computer. You are now ready to install the Microtek 
      ScanWizard scanning software.

Important:

If you are using an Adaptec-series card other than the one
provided with your scanner, you will need to contact Adaptec to
obtain the latest version of Windows NT drivers for your
interface card. Adaptec drivers shipped before August 1996 may
not work properly and may cause communication problems. You can
download current drivers from Adaptec's homepage at:

http://www.adaptec.com.

B.   Installing the Microtek ScanWizard scanning software (Red or Green CD)

Note: If you are installing the software as an upgrade, refer to section C
before installing the software.

1.    Insert the CD into your computer and run the cdsetup.exe program.
      (This program should run automatically on your system.)
2.    Click on each program to install it and follow the instructions on 
      the screen.

C.   Installing ScanWizard as an upgrade 

Before installing a new version of ScanWizard, you will need to delete 
the previous ScanWizard software on your hard drive. Follow these steps 
before installing the new version of ScanWizard:

1.  Go to the MS-DOS prompt. (Start; Programs; MS-DOS)
2.  Type: CD\WINNT
3.  Type: del Twain_32.dll
4.  Type: cd Twain_32
5.  Type: deltree scanwiz
6.  Type: Y and press the ENTER key.
7.  Go to Section B for instructions on installing ScanWizard.